Using
the knot in this
video and starting with three pieces of rope that are about 7 feet
long you can make a ball gag. Start in the middle of each piece so you
end up with six leads. Once the ball is complete take two of the leads
and tie an overhand knot about 5 inches away from the ball. These two
leads go up around the nose and the knot should land around the top of
the nose or forehead. Two leads can go straight back, and two can go
down around the chin, crossing before going to the back of the head.
All the leads will meet in the back of the head and can be tied
together.
Once
again an innocent seeming knot can be put to naughty purposes. The bottle sling knot
is handy for carrying your beer and water bottles; it also makes the
perfect dildo holder. Most dildos come with a flat base. If you slip
the bottle sling knot around the base of the dildo and tighten, it will
be securely attached.
On one end you have a loop, and on the other you have two long leads.
Position the dildo on the pubic area with the loop going forward and
up. Bring the lead through the crotch to the back. Now make an "L" and
loop the lead around the waist, going through the loop in the front.
continue to the back and wrap the lead around the "L" and reverse
directions to make a 'corset." Loop back around the front and repeat.
You will end up with a belt of rope around the waist holding the dildo.
Remember that the dildo can be facing "in" or "out." Nice! If it is
facing in, you can go between the legs again and over the base of the
dildo to make sure it stays put.